4 Dirty Little Tips On Peugeot 3008 Key Fob And The Peugeot 3008 Key Fob Industry

· 4 min read
4 Dirty Little Tips On Peugeot 3008 Key Fob And The Peugeot 3008 Key Fob Industry

What You Should Know About Your Peugeot Key Fob

Peugeot Key Fob is a useful feature that allows drivers to start their vehicle from a distance. This is beneficial during temperatures that are hot or cold as it permits drivers to warm up the engine and the interior before entering the vehicle.

Car dealerships can create and program new Peugeot keys for you, but only if you have the time to wait weeks for them to do it. KeyNOW is the only place where you can get your keys. KeyNOW  peugeot key fob  can cut the keys, program them and then deliver new Peugeot keys to you, a lot quicker.

Keyless Entry

Key fobs can start the engine of your car. This is useful if you have to leave your vehicle during the heat of summer, or if you're carrying large objects in the boot which make it difficult to open the door manually. Press the unlock button on the key fob a several times quickly to begin the car. The door locks will close and the red light will begin to flash. If this does not occur then your key fob battery may be dead and needs to be replaced. Alternately, interference from RF caused by nearby buildings could interfere with your system.

Another cool feature is that certain key fobs are equipped with a physical key that can be used to unlock the car (often only for the door of the driver, but sometimes for the boot too). They can typically be opened by flipping up the flap on the fob, or by pressing a button on the case. The key's physical form can be pulled out of the slot in the case.


Key fobs can be damaged by water, especially when the chips are exposed to soapy or salty water. In some instances key fobs may cease working completely due an issue with the chip. If this happens the key fob has to be replaced, usually by the dealer. Locksmiths can provide replacement keys much faster and at a lower price than dealerships.

Remote Start

You can start your car without having to carry your keys on you. This is especially useful when it's hot out and you want to cool down your car while you run the errands. There are a few points you must know before you can use this feature.

Some key fobs feature a specific remote engine start button (for instance Ford's keyfob has an arrow that is circular and going clockwise) which you must press in order to remotely start your car. Others, such as Mazdas requires that you first secure the key, and then press the start button.

There may be a dead or weak battery in your key fob if you aren't able to start your car. The battery in the key fob isn't powerful enough to send a signal to your car system.

If this is the case, you'll need to replace the batteries in your key fob or try programming it. The procedure varies for each vehicle, however the instructions are usually found in the owner's manual. Our mobile technicians are also equipped to assist you in this procedure. We have the expert equipment needed to cut and program the replacement Peugeot keys at your home, office or even when you're stuck on the roadside.

Door Locks

The Peugeot 3008 remote system allows you to lock or unlock your vehicle by pressing a button on your key fob. Contrary to the traditional key, which has a physical key hole this key fob is able to store an encrypted copy of the car's key inside.

In order to accomplish this, it relies on the use of a specific radio signal that is only sent out when the key is within a specified range of the car. A solenoid inside the door lock transforms the electronic command into mechanical after the signal has been spotted. This causes a rod to turn the car door locks just as the physical key would.

If a Peugeot key fob has stopped locking or unlocking the vehicle, there are a variety of possible causes. The most frequent reason is the battery is dead. It can be repaired in a matter of minutes. Other causes include worn buttons water damage or signal interference, or a defective electronic chip.

Modern cars require a very precise level of accuracy to operate and the key fob is not immune to this. The key fob could be programmed incorrectly or it could have a hardware issue that stops the vehicle from responding to the signal sent by the key. A locksmith certified by the ICRC can reprogram your key fob to make sure it is compatible with the vehicle.

Immobiliser

Peugeot were one of the first car manufacturers to implement an immobiliser device in a key. The chip prevents the car from starting if it sees an untrue signal coming from the key to the car. When it's brand new, this is fantastic, but as they age the chips may wear out and begin to cause issues. This typically starts with an error message that says 'anti-theft system active on the dashboard or a warning light is blinking indicating "immobiliser fault".

Peugeot dealerships are usually used to design and program replacement keys. However, a professional mobile locksmith has dealer-standard equipment in their van, which means they are able to be with you and generating new Peugeot keys at the side of the road or at home, much faster than dealerships are capable of.

Generally Peugeot keys start to show issues as the key blade wears out. This wear could cause the mouth of the key not to fit into the lock correctly, which can cause further wear on the locks. The issue can be solved by simply replacing the blade. It is also possible to have the teeth of the key refurbished to ensure that they function smoothly. Only a qualified auto locksmith can do this, but it can save you a lot of time and cash in the long run.